Volume 16, Issue 18 | June 17, 2019

Energy Answers: Renewable Portfolio Standards

38 states and the District of Columbia now have Renewable Portfolio Standards.

 

In last week’s issue of Energy Update, we wrote about recent and current legislative efforts to ensure America's clean energy future. These efforts include legislation at both the federal and state levels. In at least one of the laws we highlighted, the Clean Energy DC Omnibus Amendment Act of 2018, the legislation includes a requirement relating to a Renewable Portfolio Standard (or RPS).


 
What exactly is an RPS?
An RPS is a state-level policy that requires electric utility companies and retail energy suppliers to source a specified amount of the energy they sell or generate from renewable sources. An RPS may also be called a Renewable Energy Standard (RES).

While there is currently not a federal RPS policy in place, the Solar Energy Industries Association (SEIA) reports that 38 states and the District of Columbia currently have an RPS. The requirements of an RPS can vary by state, with respect to clean energy standards (e.g., which, in some states, will allow nuclear and low-emissions non-renewable energy sources like natural gas) and renewable goals (e.g., the percentage of energy to be sourced from renewables like wind and solar).

An RPS typically establishes incremental compliance targets that increase over time. For example, in Maryland, the current RPS target requires electricity providers to obtain at least 50% of their electricity from renewable sources by 2030, and to create a plan for achieving 100% renewable electricity by 2040. In another example, pending legislation in Pennsylvania seeks to amend the state’s RPS to include nuclear energy.

It’s also common for an RPS to include a carve-out, which is a more specific requirement designed to incentivize the deployment of particular market segments or renewable energy technologies like solar. The Clean Energy DC Omnibus Amendment Act of 2018, as an example, includes a requirement that at least 5% of a utility’s or supplier’s electricity originate from long-term solar Power Purchase Agreements, or PPAs, by 2032.

What are the benefits of an RPS?
An RPS typically encourages the growth and development of all renewables, by incentivizing cost reductions and efficiency gains.

While the benefits may vary by state, territory or the District, RPS policies generally encourage the growth of domestic energy consumption, economic development, energy portfolio diversification, energy independence, job growth and a reduction in greenhouse gas emissions. 

 

Sources:
Legislators Look to a Clean Energy Future. (2019, June 11). Retrieved June 13, 2019, from http://energyupdate.wglenergy.com/wges/issues/2019-06-10/

Magazine, P. (2018, April 04). Does an aggressive Renewable Portfolio Standard increase utility rates? Retrieved June 13, 2019, from https://pv-magazine-usa.com/2018/04/03/does-an-aggressive-renewable-portfolio-standard-increase-utility-rates/

Renewable Energy Standards. (n.d.). Retrieved June 13, 2019, from https://www.seia.org/initiatives/renewable-energy-standards

Stern, A., & Stern, A. (2019, April 23). Fact Check: New Report on Renewable Portfolio Standards Misses the Mark. Retrieved June 13, 2019, from https://www.aweablog.org/new-report-renewable-portfolio-standards-misses-mark/

 


Editor's Note

Mild Start

Weekly Review June 8 - June 14, 2019

 

On Thursday, the U.S. Energy Information Administration (EIA) reported that working gas in storage as of Friday, June 7, 2019 was 2,088 BCF. This is an increase of 102 BCF from the previous week and was lower than market expectations. Inventories are now 189 BCF higher than this time last year.

Summer is off to a mild start in the Mid-Atlantic, with no significant heat experienced through the first half of June. Nationally, energy demand is running close to the 30-year normal for June, which has thus far been cooler than the 10-year normal. There are, however, indications of a warm-up in store for the Eastern part of the country during the last 10 days of June.

Overall, the PJM West Hub 12 Month curve decreased 0.4% this week while the NYMEX natural gas 12-month curve decreased 0.2%.


This past week's market information is provided as a courtesy to our customers and is not indicative of, nor should be relied upon, as representative of future transactions.


Special Offers

Get 4% Cash Back

When you buy WGL Energy electricity or natural gas for your home.

 

WGL Energy Services' (WGL Energy) 4% Cash Back Rewards is a limited-time offer and is available to new residential customers who purchase electricity or natural gas supply services from WGL Energy.

The amount of your Cash Back Rewards check is based on the electricity or natural gas supply you use during the term of your WGL Energy Supply Agreement. At the end of each year of your agreement, we'll calculate your annual Cash Back Rewards by multiplying your total electricity or natural gas supply charges by 4%.

Your Rewards check will be sent by first-class mail to the customer of record within 30-60 days of the end of each 12-month period of your initial WGL Energy agreement.

Your Cash Back Rewards applies only to your electricity or natural gas supply charges from WGL Energy. Your WGL Energy electricity or natural gas supply charge will appear as an itemized charge on your electricity or natural gas utility bill.

 

There is no cost to enroll with WGL Energy.

 

Choose your electricity or natural gas plan now to start earning your 4% Cash Back Rewards.



Weather

Local Cooling Degree Days*

 


Washington, D.C. Area Cooling Degrees Days* 

 

May - 19

Jun - 19

Jul - 19

Aug - 19

Sep - 19

 Oct - 19

 Actual

212 

 

 

 

 

 

 Normal

121

 

 

 

 

 

 Departure from Normal

 76%

 

 

 

 

 

 Warmer

 

 

 

 

 

*Cooling degree day (CDD) data is for the Washington, D.C. area and is calculated by comparing the day’s average temperature to a 65-degree baseline. If the day’s average temperature is below 65, there are no cooling degree days that day. If the day’s average temperature is greater than 65 degrees, then subtract 65 from the average temperature to find the number of cooling degree days.